Flagpoles are metal piping with thick enough walls (generally 1/4 inch thick or more) designed to withstand the wind load a flag exerts on the pole during high-wind weather conditions. Galvanized pipe is well-suited to such an application due to its resistance to the formation of rust, which could weaken the metal. Due to this resistance to rust, such pipe can be used as a permanent mast for flying a flag, where untreated steel pipe must be removed periodically and replaced with new pipe to replace a rusty, corroded section.
Mix concrete in a separate container per manufacturer's instructions. Fill your bucket up 2 inches with the concrete and allow it to sit for a short time. Place the wrapped end of the PVC pipe into the 2 inches of concrete. Use your level to make sure your pipe is straight.
Selecting the right material for your flag pole largely depends on the wind speeds typical in your area and the purpose of the pole. Aluminum flagpoles are usually used for commercial displays while fiberglass poles are best for boats, homes and side-wall mounts. To fly flags on top of skyscrapers and other tall buildings, flagpoles are made of steel. Flagpole mounting is just as important as the construction of the pole. Flag poles are usually mounted inside a pole sleeve at a depth three times the diameter of the pole. The sleeve is surrounded by cement and sealed to prevent water damage and rust.
Bolt the pulleys onto the pipe with an appropriate wrench set, placing a lock washer and nut on each. Tighten until hand-tight, then tighten further until the nuts cannot be turned anymore. Use caution so the bolts aren't stripped while tightening.
To raise or lower a flag, a person would attach the flag to the hooks and simply pull the rope until the flag reached the desired height. He would then tie the excess rope onto the pole's cleats. A person could raise the flag and be proud of his or her country.
There is a barrage of cheap and Flagpoles being imported and sold, that do not comply with the statute. This is bad for a number of reasons. Imported flagpoles are cheaply made and more importantly, the designs, materials, colors, and methods do not compare well with the better quality, longer-lasting, and correctly designed flagpoles made by American manufacturers. The Flag Company Inc specialized in flags and flagpoles designs offered a special edition of flagpoles to comfort your environment with the genius American brand flagpoles that stay for centuries to memorize the history of flagpole production for the future.
Mix concrete in a separate container per manufacturer's instructions. Fill your bucket up 2 inches with the concrete and allow it to sit for a short time. Place the wrapped end of the PVC pipe into the 2 inches of concrete. Use your level to make sure your pipe is straight.
Selecting the right material for your flag pole largely depends on the wind speeds typical in your area and the purpose of the pole. Aluminum flagpoles are usually used for commercial displays while fiberglass poles are best for boats, homes and side-wall mounts. To fly flags on top of skyscrapers and other tall buildings, flagpoles are made of steel. Flagpole mounting is just as important as the construction of the pole. Flag poles are usually mounted inside a pole sleeve at a depth three times the diameter of the pole. The sleeve is surrounded by cement and sealed to prevent water damage and rust.
Bolt the pulleys onto the pipe with an appropriate wrench set, placing a lock washer and nut on each. Tighten until hand-tight, then tighten further until the nuts cannot be turned anymore. Use caution so the bolts aren't stripped while tightening.
To raise or lower a flag, a person would attach the flag to the hooks and simply pull the rope until the flag reached the desired height. He would then tie the excess rope onto the pole's cleats. A person could raise the flag and be proud of his or her country.
There is a barrage of cheap and Flagpoles being imported and sold, that do not comply with the statute. This is bad for a number of reasons. Imported flagpoles are cheaply made and more importantly, the designs, materials, colors, and methods do not compare well with the better quality, longer-lasting, and correctly designed flagpoles made by American manufacturers. The Flag Company Inc specialized in flags and flagpoles designs offered a special edition of flagpoles to comfort your environment with the genius American brand flagpoles that stay for centuries to memorize the history of flagpole production for the future.
ليست هناك تعليقات:
إرسال تعليق